Short answer
A straightforward home EV charge point installation might cost around £800–£1,500, but longer routes and supply upgrades can take the total above £2,000. A competent EV installer must assess the supply, circuit protection, earthing and network notification before connection. If you park on the street, investigate public charging and council-approved options rather than trailing a cable across the pavement.
What does home EV charger installation cost?
For budgeting only, allow roughly £800–£1,500 for a typical domestic 7 kW smart charge point supplied and installed with a short, accessible cable route and a suitable existing supply. More involved work may be around £1,500–£2,500 or more. These are broad indicative ranges, not a tariff, quotation or promise that any particular property qualifies for a standard installation.
Cost changes with charger specification, cable length, groundworks, wall construction, parking position, consumer unit arrangements and the condition of existing wiring. Supply alterations, making good and permissions can be separate. Ask whether VAT, protective devices, testing, commissioning and Building Regulations notification are included. Compare written scopes rather than headline prices that assume ideal access.
David gives free fixed quotes for the electrical services he provides, including assessments and any separately agreed remedial work. This guide is general information about EV installation requirements; it is not a statement that David supplies or installs EV charge points. Ask a competent specialist for the charger installation quotation and confirm responsibility for any preparatory work.
Choose the charging speed you can actually use
Around 7 kW is a common domestic AC charging rate on a single-phase supply. Higher AC outputs, such as 11 kW or 22 kW, normally require three-phase supplies and a compatible vehicle. Buying a faster-rated unit does not make the car accept more power than its onboard charger allows. Look at your daily mileage and normal parking time before paying for additional capacity.
As a simple illustration, replacing 30 kWh at a steady 7 kW takes a little over four hours before losses and other limits are considered. Cold batteries, vehicle settings and load management can extend that time. Overnight charging often suits ordinary commuting without a rapid charger. Check tethered cable length against the actual position of the car’s charging socket.
A three-pin portable charging lead is not a substitute for assessing an old socket and circuit. Sustained charging can expose weak connections that do not show up during occasional appliance use. Do not use improvised adaptors or ordinary extension reels. Follow vehicle and charging equipment instructions and seek advice if a plug, socket or lead gets hot.
What the smart charge point regulations require
GOV.UK explains that the Electric Vehicles (Smart Charge Points) Regulations 2021 cover relevant private domestic and workplace charge points sold in Great Britain. Most requirements began on 30 June 2022, with additional security requirements from 30 December 2022. These are product sale requirements, not a retrospective demand to replace every older charger already installed.
Relevant equipment needs smart functionality and features including default off-peak charging settings, a randomised delay and appropriate security and information provisions. Users can override charging schedules. The purpose is to help manage demand, not to guarantee the cheapest electricity automatically. Public charge points and certain other equipment fall outside these particular regulations.
Before purchase, check how scheduling works with your electricity tariff, whether essential functions continue if communications fail, and whether an app subscription is necessary. Ask about software support and compatibility when changing electricity supplier. Keep product documentation and administrator access yourself rather than leaving the installation permanently tied to someone else’s account.
Supply checks and DNO notification
The distribution network operator, or DNO, looks after the local electricity network; it is not necessarily the company sending your electricity bill. The Energy Networks Association’s connection guidance requires the installer to assess maximum demand, supply capacity and equipment condition, then use the appropriate connection or notification route. Network notification is separate from Building Regulations notification.
Some installations can follow a connect-and-notify route; others need an application and approval before connection. Reasons to contact the DNO first include a looped supply, uncertain supply rating, inadequate capacity or concerns about service equipment. The installer should use the current ENA process and the relevant DNO’s requirements rather than assuming that every 7 kW unit can be fitted immediately.
Load management can reduce charging power while other large appliances operate, but it must be properly designed and accepted within the connection arrangements. It does not repair damaged supply equipment. Never remove service seals or alter the main fuse yourself. Ask who will submit the application, whether approval is outstanding, and what evidence you will receive after notification.
Earthing, PME and protective devices
An outdoor vehicle introduces a particular risk because someone can touch its metal body while standing on the ground. With a PME supply, a broken combined protective earth and neutral conductor on the network can create dangerous touch voltages. The IET’s guidance on open PEN protection explains why EV charging needs specific consideration beyond a normal household socket circuit.
The designer must select a compliant protective approach for the actual installation. Depending on the circumstances, this may involve suitable open PEN fault protection, an appropriately designed earth electrode arrangement or another permitted method. An earth rod is not automatically required for every charger, and a product advertised as having PEN protection still needs correct selection and installation.
The installer also needs to address overcurrent protection, RCD protection and DC residual currents in accordance with BS 7671 and the manufacturer’s instructions. Some units incorporate particular protective functions; others need additional external equipment. Ask for the design basis and test results, not just an assurance that the charger is smart or has an app. Smart functionality does not establish electrical safety.
Cable routes, permissions and certification
A dedicated charging circuit is normally required, with cable sizing based on demand, route, installation method and voltage drop. Routes through loft insulation, buried sections and exposed walls need different consideration. External cable and fixings must withstand the conditions and foreseeable damage. Avoid a position that requires the charging lead to cross steps, doorways or somebody else’s parking space.
In England, a new domestic circuit is notifiable work under Part P. GOV.UK’s Approved Document P explains the compliance routes. Agree this before work starts: a suitably registered installer can normally self-certify work within their scope, while other routes involve building control. Obtain the Electrical Installation Certificate, relevant Building Regulations compliance certificate, product instructions and commissioning information.
Leaseholders may need freeholder or managing agent consent for cable routes and equipment on shared land. Listed buildings and sensitive external alterations may need separate consent. Electrical compliance does not grant property rights or planning permission. Put permissions and responsibility for reinstating walls, paving and fire-stopping in writing before an installation date is agreed.
Charging without a driveway in south-east London
Victorian terraces in Blackheath, Lewisham and Greenwich often have no private parking immediately beside the house. A resident parking permit does not reserve the space outside your door. Options include public lamp-column or kerbside chargers, destination charging, workplace facilities and rapid charging hubs. The ENA’s guidance specifically recognises alternatives for homes without a driveway.
Check your borough’s charging information and the operator’s live map for locations, connectors, availability, payment methods and parking restrictions. Charging fees and parking charges can be separate. If local provision is poor, ask Greenwich, Lewisham or Bexley council about requesting a public point and whether any authorised cross-pavement charging scheme is available at your address.
Do not assume that placing a rubber cover over a cable makes trailing it across a public footway acceptable. A gully or other crossing requires the highway authority’s agreement and may involve additional permissions and conditions. Shared parking at converted houses needs agreement about ownership, metering, access and maintenance. Establish a lawful, practical parking solution before buying domestic charging equipment.
Prepare for a useful survey and handover
Have the vehicle model, parking layout, recent electricity information and any previous installation certificates ready. Provide photographs of the consumer unit and meter area only where they can be taken safely without removing covers. Mention electric heating, showers, solar panels, batteries and planned heat pumps because these affect demand and control arrangements.
At handover, ask for a demonstration of charging, schedule overrides, load management and safe shutdown. Record warranty details and the support contact. Keep notification evidence with the electrical certificates, and check that labels identify the new circuit. Revisit the design before adding another vehicle or large electrical load rather than assuming spare capacity remains available.
When to call a registered electrician
- The existing consumer unit has no suitable capacity or protection for a proposed new circuit.
- The service head looks damaged, the supply rating is uncertain or a looped supply is suspected.
- You need an assessment before purchasing charging equipment or arranging specialist installation.
- A charging socket, plug or cable becomes hot, damaged or discoloured during use.
- Charging repeatedly trips protective devices or fails when other large appliances run.
David J Farrar & Associates are Part P, NAPIT and NICEIC registered with over 35 years' experience across Blackheath, Lewisham, Greenwich, Bexley and North Kent. Call 07977 519533 or send an enquiry for a free, fixed quotation.
Related services
- Electrical Health Checks — Peace-of-mind safety checks for older homes, new purchases and growing families.
- Consumer Unit & Fuse Board Upgrades — Replacement consumer units and fuse boards, with electrical testing and certification.
- Additional Sockets — More sockets where you need them — fewer extension leads, less overloading.
Frequently asked questions
Does every EV charger need an earth rod?
No. The appropriate earthing and open PEN protection depend on the supply and installation design. A competent EV installer must establish a compliant solution rather than fitting or omitting an electrode as a blanket rule.
Can I install a 22 kW charger at home?
Usually only where there is a suitable three-phase supply and the vehicle can accept that AC rate. A supply upgrade can be substantial, so compare its cost with the charging speed you genuinely need.
Does the DNO have to know about my charger?
Yes, the applicable network connection process must be followed. Some installations qualify for notification after connection; others require advance approval. Your installer should assess the criteria and provide evidence of the submission.
Can I charge across the pavement outside my house?
Do not assume you can. Contact the highway authority about local rules and any approved crossing scheme. Public charging or workplace charging may be a more practical option when there is no private parking.
Will a smart charger always choose the cheapest tariff?
No. It can schedule charging, but you must check tariff times, settings and compatibility. Default off-peak settings are not a guarantee that charging will always take place at your supplier’s lowest price.
Official sources
Need this sorted? Get a free, fixed quote from a registered local electrician.
07977 519533Enquire onlineThis guide is general information about UK electrical regulations and good practice, and any prices are indicative only. For advice on your property, speak to a registered electrician.

